Appliance Repair Help
Quality Factory Appliance Parts
Quality Appliance Service
Common Parts
::  Washer Parts   
::  Dryer Parts   
::  Refrigerator Parts
  
::  Dishwasher Parts
::  Range/Oven Parts  
 
::  Icemakers & Icemaker Parts  
 
Monthly Special  
:: GE  Refrigerator Water Filter  2 Pack     
:: MWF2  2 Pack     
$69.95
Save 13%
Lane Appliance
__________
__________
----------------
__________
__________
----------------
Quality Parts  
        &          
Service  
::  Factory Authorized Parts  
::  Same Day Shipping  
::  Most Parts In Stock  
::  Call Toll Free Today!  
::  1-866-745-2554  
::  Same Day Service  
::  90 Day Labor Guarantee  
::  Free Online Repair Help
::  Over 15 years Experience  
::  Professional & Courteous
Testimonials
Thank you for the way you handled my
microwave repair. I can see you are in
business to build relationships and can
look past the short term. I will not hesitate
to refer you to my friends and family.

Trudy M.
Thank you again for your helpfulness. We
certainly recommend the quality and
helpfulness of your work and the integrity
of the way you do it, every chance we get.

Katie O.
More
Monthly Tip  
Cleaning out the lint build up inside your
dryer is very important.  The accumulation
of lint can catch fire and spread to your
home. The lint will also act as insulation
on your motor and cause premature
failure.  All dryers and there vents should
be cleaned at least once a year. Doing
this will keep your family safe and your
dryer operating.
If your Roper dryer is completely dead then it could just be a bad door switch or
an
open thermal fuse.  The door switch is a safety device that shuts the dryer off
if the door is opened or keeps it from turning on when the door is open.

Check and make sure you have power to the dryer.  This can be done with a
volt/ohm meter(A must have!).  If its a gas dryer nd you don't have a meter than
you can plug a small appliance into the outlet to make sure its working.  No
power= call an electrician.   If you suspect a bad door switch then follow
instructions below.


1.  On most models the switch can be checked by raising the top of the dryer.  
Raising the top can be accomplished by removing the 2 screws under the lint
filter.

2.  After the screws are removed grasp the top on the sides with both hands and
pull forward and up.  The top will then hinge to the back and now you can visibly
see the switch.

3.  An Ohm Meter is necessary to check the switch.  The switch should have
markings on it reading NO, NC, and COM.  

4.  If a bad switch is found to be the cause of failure, then remove the old switch
by removing the 2 screws fastening the old switch to the front panel.  Use all the
parts given with the new switch and reinstall wires as removed.  

5.  Reassemble the dryer and test.

You just saved yourself some money!
Please remember that working on appliances can be dangerous.  Appliances have many
mechanical and electrical parts that can cause serious injury and death.  If you aren't familiar
with these types of applications then please call a qualified appliance technician. Lane
Appliance LLC and this site accept no responsibility for injuries to person or damage to
appliances.
Did this site save you an expensive service call? Please show thanks and......
    Roper Dryer Will Not Run
Roper Dryer Door Switch Kit
La Porte
Michigan City
South Bend
Toll Free
219.369.9947
219.879.7858
574.289.5263
866.745.2554