Whirlpool Dryer Coil Kit
Maytag Dryer Belt
Appliance Repair Help
Quality Factory Appliance Parts
Quality Appliance Service
:: GE Refrigerator Water Filter 2 Pack
:: MWF2 2 Pack
:: Factory Authorized Parts
:: Same Day Shipping
:: Most Parts In Stock
:: Call Toll Free Today!
:: Same Day Service
:: 90 Day Labor Guarantee
:: Free Online Repair Help
:: Over 15 years Experience
:: Professional & Courteous
microwave repair. I can see you are in
business to build relationships and can
look past the short term. I will not hesitate
to refer you to my friends and family.
Thank you again for your helpfulness. We
certainly recommend the quality and
helpfulness of your work and the integrity
of the way you do it, every chance we get.
Cleaning out the lint build up inside your
dryer is very important. The accumulation
of lint can catch fire and spread to your
home. The lint will also act as insulation
on your motor and cause premature
failure. All dryers and there vents should
be cleaned at least once a year. Doing
this will keep your family safe and your
If your dryer sounds like it is running but the drum
doesn't turn then it is likely a broken belt.
Unplug the electric for the dryer.
On most models the belt can be checked by
raising the top of the dryer. Raising the top can
be accomplished by removing the 2 screws under
the lint filter. After the screws are removed grasp
the top on the sides with both hands and pull
forward and up. The top will then hinge to the
back and now you can visibly check the belt.
If you don't see the belt around the drum then it
has broken and fallen down to the bottom. If you
see the belt on the drum, try lifting it. If the belt
pulls away from the drum then it is broken. If it
doesn't pull away then you will have to look for a
If you have a broken belt then here is how you
First verify that the front panel is all one panel or
two panels. If it is two panels then you will have to
start by removing the bottom panel. This can be
accomplished by pulling on the sides of both
panels until it flips down or inserting a putty knife
into the top of the lower panel on both sides to
release the retaining clips. If your dryer is the
type with the top retaining clips then be careful
not to pull on the sides as this will damage the top
Now that the lower panel is removed you will have
to remove the 2 screws at the top of the upper
panel and loosen the 2 screws at the bottom of
the upper panel. Remove the wire harness or
terminal leads to free top panel from dryer. Be
careful to properly mark the wires so you install
them correctly when reassembling.
If your model is just one front panel then you just
remove the 2 top screws, remove wires or
harness, and lift panel up and away from dryer.
Now you can remove the old belt from the dryer
and install the new one.
You will be able to see where the old belt rode on
the drum. Make sure the new belt is placed in the
same spot or it will throw the idler and come off
When belt is around drum, loop belt under idler
and around motor pulley. The idler is meant as a
tensioner for the belt.
Reassemble the dryer.
Please remember that working on appliances can be dangerous. Appliances have
many mechanical and electrical parts that can cause serious injury and death. If
you aren't familiar with these types of applications then please call a qualified
appliance technician. Lane Appliance LLC and this site accept no responsibility for
injuries to person or damage to appliances.
Estate Dryer Belt
|Did this site save you an expensive service call? Please show thanks and......